We all know that Superfine Steam Jet Mill Equipment is a very strong airflow crushing equipment, many stubborn hard materials that encounter the crusher to be cut into a uniform block,
Superfine Steam Jet Mill Equipment is used to crush the item, then the crushing items and tailings will also be discharged in time. When the crusher discharges these crushing items, there will be dust.
How do you solve if the dust is too big?
1, install the dust collector: Generally, this dust collector can now be used with a pulverizer. It plans dust income to the bag, and the dust is filtered by the dust box;
2, cloth bag dustproof: cloth bag is tightly pulled with machine, prevent leakage powder. Attention should be paid attention to parking, and it should be cleaned with dust during parking.
3, woodllar or pool dust removal: Mainly using the ventilator to vacuum to the pulverization, then vacuum, or vacuum through the pool.
The three dust removal methods of
can achieve good dust removal effects, which can solve the problem of excessive dust, and will be installed before working to prevent excessive dust.
In conventional dispersion pulverization processes, it is difficult to overcome the phenomenon of heating, viscosity. The machine uses a swirling high-speed rotational movement to produce a strong gas stream within the mill. The material enters the crushing room under the negative pressure of the feed port. The vortex vibration generated by the strong gas flow between the blade and the module is generated by impact, shearing and grinding. The heat of the pulverizer is taken away by the airflow, and the heat generated during the crushing process will not accumulate. The finished powder from the screen stream, improves the milling fineness, can be adjusted by the screen production efficiency, uniform fineness.
In the production process, the temperature rise of the bearing must be often checked, and when the temperature rise exceeds 50 ° C, it should be closed, and the reason is to rule out the fault. When the new machine is running, the transmission belt is easy to elongate, pay attention to adjust the appropriate looseness of the belt to ensure the work life of the belt. If you want to check, you should replace production quality and production in time. Blades, the lining should often check the wear situation. If the wear is worn, the productivity decreases, and the particle size is replaced after the particle size is replaced. The host and the grading flow bearing are lipids, and the 2nd special lipid is used. The replacement period of the bearing is around three months, and the filling of the grease is 1/2 of the outer space space in the bearing cavity. Do not fill the grease. Otherwise It will cause too high of the bearing temperature. The spiral feeder has changed the lime than half a year, and the calcium-based grease is added. In the output shaft E, ie the pulley E, avoiding heavy hammer, damage the part. It is strictly forbidden to turn the handle on the stop. The lubricating oil used in this regulator is used with N32 alkaline high-z7-degree anti-motor oil pressure oil, and the deceleration machine is used 401 generally lubricating oil, and it is not necessary to use other machines. After four or five months, new oil should be replaced.
Technical parameters:
finished particle size: 98% over 325 meshProduction capacity: 2T
There are still many usage specifications for Superfine Steam Jet Mill Equipment, and I want to learn more about super. Friends of fine gas flow grades welcome to consult with us!
