As is well known, Steam Jet Mill Grinder for Quartz Powder has received extensive attention from the industry.
Steam Jet Mill Grinder for Quartz Powder temperature is also a factor affecting work efficiency. When the temperature of the working fluid is too high, the flow rate of the gas will increase. Take air as an example, the critical speed at room temperature is 320 m / sec, when the temperature rises to 480 ° C, the critical speed can be increased to 500 m / sec, that is, the kinetic energy increases by 150%. Therefore, increasing the temperature of the working fluid is conducive to improving pulverization. The pressure of the working fluid is the main parameters of the jet speed, but also the main parameters affecting the fineness of the break. Typically, the higher the pressure of the working fluid, the faster the speed, the greater the kinetic energy. When the titanium powder is pulverized by superheated steam, the vapor pressure is usually from 0.8 to 1.7 MPa, and generally pulverized calcined material is high, and the material after the pulverized surface is low.
What is the hierarchical principle and process of Steam Jet Mill Grinder for Quartz Powder? Below, below share.
1. Open the switch in the control cabinet, start the power supply, equipment operation;
2, the raw material enters the feeder
3, the raw material enters the feeder injector in the feeder
4, the raw material reaches the hierarchical body after special dispersion, grading through physical effects such as airflow and gravity;
5, the airflow of the three flow paths has the control valve group adjustment to maintain their respective balance;
6, grading The rear coarse fine product is recovered separately;
7, clean air is discharged into the atmosphere.
In the production process, the temperature rise of the bearing must be often checked, and when the temperature rise exceeds 50 ° C, it should be closed, and the reason is to trigger the failure. When the new machine is running, the drive belt is easy to elongate, pay attention to adjust the proper looseness of the belt to ensure the work life of the belt. If the lifting piece should be checked frequently, replace the production quality and production in time. The blade, the bushing should often check the wear situation. If the wear is worn, the productivity decreases, and the particle size is roughly discovered to be replaced. The host and the grading flow bearing are lipomatic lubrication, using special lipids, the replacement period of the bearing is around three months, and the filling of the grease is 1/2 of the interior space in the bearing cavity. Otherwise, It will cause too high of the bearing temperature. The spiral feeder has changed the lipid period of half a year, and Cape Calcium-based grease. In the output shaft E, ie the pulley E, avoiding the weight of the weight, damage the part. It is strictly forbidden to turn the handle on the stop. The lubricating oil used in this regulator is used with N32 alkaline high-zinc high-grade anti-motor oil pressure oil, and the deceleration machine is 401 generally lubricating oil, and it is not necessary to use other machines. After four or five months, new oil should be replaced.
AlPa Iron STEam Jet Mill Grinder for Quartz Power Case Sharing: The customer's main business is the production and sales of special powder for rust-proof pigments and diamond tools industry.The raw material production and processing, new products are developed in one, with a production and sales enterprise of phosphate, such as mining, smelting, powder, and new materials. The customer needs to perform airflow grading to the iron phosphate ultrafine powder, eventually experimenting with our company's grading function to meet the customer needs.
Product particle size: D97: 18UM
Hour Yield: 80kg / h
