Steam Jet Mill Crusher for coating can be used for important or need to be grounded to granular product processing, AlPA ultrafine pulverizer products are good, affordable, factory direct sales, also push after-sales service service for customers, service attitude
A Steam Jet Mill Crusher for Coating costs, if you want to use Steam Jet Mill Crusher For Coating for a long time, please pay attention to the following:
1. During the production process, Check the temperature rise of the bearing, when the temperature rise exceeds 50 ° C, the examination should be stopped, find out the cause, and troubleshoot.
2. When the new machine is running, the transmission belt is easy to eliminate, so it should be noted to adjust the appropriate tightness of the belt to ensure the life of the belt.
3. Test and timely replacement of vulnerable parts should be performed in time to ensure quality and production.
4. The wear of the blade and bushing should be continuously checked. If the productivity is lowered, the particle size is thick after wear, and the wear is immediately replaced.
5. Stern Jet Mill Crusher For Coating host and level distribution bearing uses special grease (265-295 degrees) lubrication.
6. The replacement period of the bearing is 2000 hours, and the amount of oil filling of the bearing chamber gap is 1 ≤ 2 (try) or 3 ≤ 4 (try), if it is not too much, the bearing temperature Will be too high.
7. The replacement period of the spiral feeder is 4,000 hours, and ordinary calcium based grease is added. Standard operation to exchange for longer use of airflow crushers.
The above is a 7 point introduction to the day-to-day maintenance of Steam Jet Mill Crusher for Coating.
Next, we understand the working principle of the ultrafine pulverizer.
When working, the material to be pulverized from the feed hood on the side of the hood shell, relying on the grinding roller device suspended on the main plum flower frame, rotating around the vertical axis, and itself is rotated, due to rotation The role of the grinding roller is swing outward, pressing the mill, so that the shovel shovel is sent between the mill and the abrasive ring, and the purpose of the pulverized material is achieved due to rolling rolling of the grinding roller. Warlective process: After the material is ground, the fan blows the wind into the main casing, blows the powder, and is selected from the analyzer above the grinding chamber, and the fine material is refined into the grinding chamber. The style of constructing the wind flow into the cyclone collector, and after collecting the powder, it is the finished product.
The wind is collected by the big cycloneThe back air in the upper end is reflected in the fan. The wind path is cycled, and in the negative pressure state flows, the air volume of the circulating wind turbine increases the exhaust gas pipeline between the flowers and the main unit, enter the small cyclone collector, and purify .
After long-term use, it is necessary to clean Steam Jet Mill Crusher for Coating. Before the airflow pulverizer is cleaned, all machines should be disassembled. When cleaning, the power supply can be turned off, and the remaining dust can be removed directly with a brush. We must remember to clean it layer by layer. When the displacement is unloading, you can remove the four screws on the base, then remove the hopper. When sieved, the air pulverizer door can be opened directly, and finally the screen can be disassembled. After removing the movement gear, release the fastening nut first, then separate the live teeth from the spindle. Then remove the active gear and place it safely. Remove the fixed gear, remove the screw and remove the fixed gear. Be careful when disassembling the air pulverizer and must never be damaged by machine components.
The customer needs to perform airflow grading to the iron phosphate ultrafine powder, eventually experimenting with our company's grading function to meet the customer needs.
Product Parts: D97: 18UM
Horses Yield: 80kg / h
